Submersible pump fresh water suitable for Hymer Grand Canyon S incl. CrossOver

Maintaining the water flow in your motorhome

Life in the Hymer Grand Canyon S incl. CrossOver is a dream for every traveler. The freedom to explore the world while enjoying the comfort of your own motorhome is a priceless experience. But what happens when the water flow stops? This can be caused by various problems, whether it's a fuse, a faulty microswitch on the tap or the pump itself, which likes to give up after a few years. In this article, we will take a closer look at replacing the fresh water tank pump and show you step by step how to fix this problem.

The function of the fresh water tank pump

The pump in your motorhome plays a crucial role in the water supply. It pumps the water from the fresh water tank to your tap and thus ensures that you have access to clean water everywhere in your Hymer Grand Canyon S incl. CrossOver. If the pump stops working, this can significantly affect your journey.

Step 1: Diagnosis of the problem

Before you replace the pump, you should make sure that the problem is actually with the pump. First, check the fuses to make sure they are OK. If the fuses are intact, you should check the microswitch on the faucet. If the switch is not activated, the pump will not be activated. Make sure the switch is working properly before taking any further steps.

Step 2: Procurement of the replacement pump

If you determine that the pump is the problem, the next step is to get a replacement pump. You can purchase replacement pumps from your local motorhome accessory store or online. Make sure you choose the right pump for your Hymer Grand Canyon S incl. CrossOver model.

Step 3: Preparation

Before you start replacing the pump, you should make sure that your fresh water tank is empty. This will prevent water from leaking while you remove the pump. Also switch off the power supply to the pump to avoid injury.

Step 4: Removing the old pump

To remove the old pump, you must disconnect it from the water pipes and the power supply. Make sure you loosen all screws and connections carefully. Be careful not to cause any damage.

Step 5: Installing the new pump

Install the new pump in reverse order. Connect the water pipes and the power supply and make sure that everything is tight. Make sure to check the seals and sealing materials and replace them if necessary.

Step 6: Tests and verification

After installing the new pump, it is important to carry out a test run. Switch on the power supply and check that the pump is working properly. Look for leaks or unusual noises that could indicate problems.

Step 7: Conclusion

Once you are sure that the new pump is working properly, you can refill your fresh water tank. You are now ready to continue your journey in the Hymer Grand Canyon S incl. CrossOver without having to worry about the water supply.

Conclusion

The fresh water tank pump in your Hymer Grand Canyon S incl. CrossOver is crucial for your comfort during your travels. Replacing a faulty pump can make the difference between a trouble-free adventure and unwanted interruptions. With these steps, you should be able to replace the pump yourself and prepare for a smooth journey.

Frequently asked questions

1. how often should the fresh water tank pump be replaced?

The service life of a pump can vary, but it should generally be replaced every few years.

2. what safety precautions should I take when replacing the pump?

Make sure that the power supply is switched off and the fresh water tank is empty to avoid accidents.

3. can I replace the pump myself, even if I am not an expert?

Yes, with the right instructions and a little manual skill, you can replace the pump yourself.

4. are there ways to extend the service life of my pump?

Yes, regular maintenance and avoiding dry operation can extend the service life of your pump.

Technical data:

• Delivery rate: 19 l/min
• Pressure: 1.1 bar